(3)Manually calibration:
FOCUS
ZOOM
IRIS
OFF/ON
CHANNEL
Press the button
for three second.
Hold the button down
for three second.
Button
Function
Switch signal channel
Calibration lens stroke
Lens travel limit
Switching control channel
Switched ZOOM and IRIS controlled parts
Control speed of Pull-push Lever
Switch Motor Rotate Direction
ON/OFF
FOCUS
ZOOM
IRIS
7
WWW.PDMOVIE.CO.UK
REMOTE AIR 4 User Manual
Controller PD2-HT Instruction Table Of Button
6.Calibrate Lens Cycle
(1)Press and Hold the FOCUS, ZOOM, or IRIS button on the controller for three seconds, until the motor rotates. The
motor will automatically rotate the lens and calibrate internally. Multiple motors will be detected simultaneously, if
multiple channels are being used.
(2)Press and hold the button on the bottom of the motor for three seconds, until the motor rotates. The motor will
automatically rotate the lens and calibrate internally. When multiple channels are being used, the motors need to
be operated one by one.
1.Turn on the motor.
2.When the motor gear and the lens gear are completely interlocked, turn the lens to the desired starting point and
hold for 0.5 seconds.
3.Then turn the lens to the end point and hold for 0.5 seconds.
4.Finally turn the lens back a little bit. The manual calibration is complete. (The lens of the focusing infinite position
can reference the numerical setting of the infinity and the nearest focal length.)
7.Use
Turn the handwheel and rocker levers on the controller to check that the corresponding motors are working
normally. The rotation speed and direction can be changed on either the motor or controller. For more detail,
please consult the below table on the button functions of the controller and motor.
Button input frequency
Turn ON/OFF
