Your Source for Healthcare and
Wellness Infotainment
™
MODEL NUMBER:
PDI-P15X
Document Number:
PD196-134R6
Support Arm Mounted Television
Page 3 of 6
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
INSTALLATION ON SUPPORT ARM
The PDI-P15X television is designed to attach to a wall mounted suspension arm capable of supporting a television weighing 12 pounds. The single
coaxial cable on top of the TV is used to supply either low voltage AC or DC power (28VAC or 24VDC) and the RF signal to the television.
DANGER: ARM RECOIL
HAZARD
The safety brake pin must
remain in the SAFETY
BRAKE PIN HOLE whenever
the television is removed
from the arm or when the
arm is removed from the wall
bracket to prevent the arm
from springing open.
1.
Remove and save the Retainer Bolt and
Lock Washer from the TV’s swivel.
2.
Remove the two Nose Cover Retainer
Screws and raise the metal nose cover.
3.
Slide the TV’s swivel completely into the
arm’s clevis (slot) such that the Upper and
Lower Swivel Plates sandwich the arm’s
nose. The nose of the support arm should
rest between each plate.
4.
Align the Retainer Plate’s mounting hole
over the arm mounting hole. Thread the
Retainer Bolt with Lock Washer through
the Top Retainer Plate, the arm’s nose and
then into the Lower Retainer Plate.
Tighten.
5.
The coax cable in the nose of the arm
should be joined with the coax cable from
the television. Wrench tighten the
connection and cover by sliding the plastic
boot sections into mating position.
IMPORTANT:
Finger Only tightening of
this cable connection will result in reliability
problems weeks or months later. Because
the TV draws its power current through this
connection, eventually the finger-tightened
connection will loosen due to thermal
cycling, develop resistance and prompt a
service call. Wrench tighten all “F” fitting
connections!
6.
For
PDI-500
series arms remove the
Safety Brake Pin from the Safety Brake Pin
Hole, reattach the acorn nut to the pin, and
store the assembly inside the nose of the
arm by attaching it to the coax cable using
the attached plastic clip. For
PDI-405
series arms remove the Safety Brake Pin
from the Safety Brake Pin Hole and install
thru rear mounting holes of the nose cover.
Securely tighten.
DO NOT
store the pin
inside the nose of PDI-405 series arms.
7.
Close the metal nose cover onto the nose.
Reinstall the two Nose Cover Retainer
Screws.
Safety
Brake Pin
Safety Brake
Pin Hole
Retainer Bolt
Lock Washer
Nose Cover
Retainer Screws
Upper Retainer
Plate
Lower Retainer
Plate
