Communication
Systems Inc.
PDI-P26LCDD Quick Start Guide
Page 6 of 7
Better Solutions Are Within Reach™
INSTALLATION INSTRUCTIONS
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH +1-937-743-6010 PH +1-937-743-5664
Document Number: PD196I127R1.DOC
PROGRAMMING
NOTE:
The remote control (PD108-427) is also performed all setup operations for the television and a password is
needed to enter the setup mode. The following instructions assume you have correctly mounted the TV, wired an external
pillow speaker, and connected an RF coax cable signal, and AC power cord to the TV.
Channel Setup
The TV offers three different programmable channel banks or Service Levels to program. Only one Service Level is
usable at a time.
Four different tuning types are available depending upon the healthcare facilities’ signal style.
Selection of the correct signal type is required for the TV to recognize all possible channels and before any channel
programming can begin.
1.
Press the SETUP button to display the SETUP MODE menu.
2. Press
the
▲
/
▼
direction button to select Signal.
3. Press
◄
/
►
direction to select Air, Cable STD, Cable IRC or Cable HRC. NOTE: Most hospitals use the Cable STD
signal style.
Auto Program
The TV automatically scans each available channel for activity. Channels that display activity are memorized into the
selected Service Level.
1.
Press the SETUP button to display the SETUP MODE menu.
2. Press
the
▲
/
▼
direction button to select Mode.
3. Press
◄
/
►
direction to set the scope of channel scanning.
Analog Only: TV searches for analog channels only.
Digital Only: TV searched for digital channels only.
Analog and Digital: TV searches for both analog and digital channels.
4. Press
the
▲
/
▼
direction button to select the Channel Sequence menu item.
5.
Press
◄
/
►
direction to set the Channel Sequence in which the channels are displayed after searching.
Interleave A+D: In the order of channel number regardless of the system.
All A then D: Digital channels are displayed after all analog channels.
6.
Press the
▲
/
▼
direction button to select the Service Level you wish to program. The menu displays the current
programming status of each level as either Programmed or Blank. NOTE: A Programmed service level can also be re-
programmed if desired.
7.
Press the
►
direction button to start auto programming.
All manuals and user guides at all-guides.com
all-guides.com