PAGE 15
Class 1 Medical
Rev. 0
been completed in accordance with these instructions. DO NOT over tighten hardware attaching to the frame.
This could cause damage to the frame tubing.
Tools Required
Philips Screw Driver
Allen Key………………………………………………..
□1/8”
□5/32”
□3/16”
Adjustable or Open End Wrench……………
□7/16”
□1
-1/4”
□1
-5/16”
Socket Head Driver with S
ocket Heads....□9/16”
□3/4”
□1
-1/4”
9.2
Cleaning
Periodic cleaning of all surfaces will help keep your wheelchair looking good and operating properly. All
surfaces can be cleaned using warm water and a mild soap solution. Do not use abrasive cleaners on any
surfaces.
9.3
Suggested Maintenance Procedures
1.
Before using your PDG Stellar LEAP, make sure all nuts and bolts are tight. Check all parts for damage
or wear and replace them if necessary. Check all parts for proper adjustment.
2.
Keep quick-release axles, if applicable, free of dirt and lint to ensure positive locking and proper
operation. Refer to ADJUSTING THE QUICK-RELEASE AXLE in section 10.6 of this manual.
3.
If applicable, oil quick-release axles at least once (1) a month (3-in-1 oil or equivalent).
WARNING
– If pneumatic tires are used, do not use the wheelchair unless it has the proper tire pressure (psi).
DO NOT over inflate the tires. Failure to follow these suggestions may cause the tire to explode and cause
bodily harm.
4.
If tires are pneumatic, recommended tire pressure is listed on the side wall of the tire.
5.
The wheels and tires should be checked periodically for cracks and wear, and should be replaced when
necessary at your authorized dealer or by a qualified technician.
6.
For wheelchairs with hard rims, periodically check hand rims to ensure they are secured to the rear
wheels.
10
SET UP & ADJUSTMENTS
10.1 Front Rigging
WARNING
– After making adjustments, always make sure that parts are properly replace and tightened
BEFORE using the wheelchair.
Easy-Out
TM
Plug in 70° Front Rigging Footrest Assembly Installation
1.
To mount the easy out plug-in front rigging, activate the lever located under the plug-in and slide the front
rigging into the open square tube receiver (seat rail). The Front rigging will lock into position when the
lever snaps through hole located on the bottom of the square receiver tube.
2.
To release front rigging, activate the trigger to disengage the lever and slide the front rigging forward and
out of the open square seat rail extrusion.
