PDC spas Aruba LX, Руководство пользователя

Страница: 36 / 52

General Guidelines
1. be sure that the power is turned off at the main circuit breaker.
2. CAUTION: Electric heater element must be fully submerged in water before being energized.
3. Fill spa to the recommended level, assuring all suction outlets are covered with water.
4. Make sure valves on the suction and return sides of the spa pump are open to allow water to flow
to and from the spa and spa support system.
5. Carefully open the air bleeder valve found on the top of the filter until water flows out of the
top of the valve. Close valve. IF the pump is air-locked, locate pump #1, loosen return fitting from the
top of the pump a few turns. After about 10 seconds, tighten union and continue start-up.
6. Turn power “on” at main circuit breaker.
7. Press jet / pump button to activate cycle.
8. Turn all air regulator knobs to “off” position.
9. When the system has fully primed, all the jets should be freely rotating and free of excess air;
except the jets attached to ozone, if this option is included on the system. Allow the system to operate
for five minutes in this position.
10. Set the thermostat to the desired temperature to begin heating the spa water. The indicator icon
on the spa side control will be on when the spa is heating.
11.The economical, gradual heating of the water takes place over a number of hours, depending upon
the size of the spa, size of the heater and the recommended use of a PDC spa cover. When the desired
temperature is reached, not over 104˚F (40˚C). leave the thermostat at this setting, the temperature
will automatically be maintained. Re-check water temperature with an accurate thermometer before
entering the spa.
12. Set the filtration program to desired setting per instructions found in the Control Center
section of this manual.
13. Chemically treat the spa water. Read the section on Water Chemistry Maintenance and follow
instructions on container of any product used.
14. Cover the spa with thermal cover to maintain temperature and lock for safety.
Initial Start-Up
31