PCO.IMAGING pco.1200 hs, Руководство пользователя

Страница: 9 / 44

Chapter 1
‚
Introduction
page 9
has been detected. Afterwards, the typical Windows
hardware drivers’ installation process will begin. At this
point, you are asked for the location of the corresponding
*.inf file. Please click on the drive where the CD has been
inserted or to the directory where the installation software
has been downloaded. Windows will perform any further
installation and system registration automatically.
Camera Link
The hardware driver required for the Camera Link frame
grabber is found as part of the frame grabber setup pack-
age, and should be available from the frame grabber
manufacturer. Installation instructions for the hardware
driver should be available in the frame grabber instruction
manual.
Ethernet and Gigabit-Ethernet
Drivers for ethernet interfaces or interface cards may be
found as part of the Windows XP operating disk or are
available with the frame grabber materials. The installation
of any additional hardware drivers should not be neces-
sary.
1.7 Imaging Optics Details
1.7.1 Lens Mount
The pco.camera family is supplied with either a standard
C-mount or a Nikon F-mount adapter. For image sensor
formats of 1/3“, 1/2“ and 1“ we recommend the use of C-
mount lenses. For the 1-1.5“ range there are special C-
mount lenses available, but most often, F-Mount lenses
should be used. For cameras with a sensor format larger
than 1.5” (pco.4000), only F-mount lenses should be
used. The distance between the front edge of the C-
Mount and the CCD sensor is 17.52 mm. Change the dis-
tance of the lens, support plate to the Image Sensor.
1.7.2 Back Focal Length Adjustment
In some cases, it may be necessary to change the dis-
tance of the lens support plate to the image sensor (e.g.,
if the camera cannot be focussed in the infinite position).
Use the small Allen wrench included in the camera pack-
age for this purpose and follow the directions below,
based on your adaptor type.
C-mount-adaptor
Loosen the two Allen screws, located at the steel insert in
the front of the camera case and adjust the knurled insert
(M50 x 0.5 thread) to the correct distance between lens
support plate and the image sensor. If you want to adjust
for the infinite position of the lens, the lens must be set to
infinite before you begin. Then the knurled insert can be
adjusted with the connected lens until you see a sharp
image, with the
camware software in recording mode or
with Live View running.
User Manual pco.camera status 12/2004