PCM DI Catanium CES, Руководство по эксплуатации и техническому обслуживанию владельца

Страница: 21 / 70

17
L510010D-17
OPERATING INSTRUCTIONS - 5
WARNING
The machinery space must be closed anytime the
engine is running to prevent injury to you or others
on board. Never operate the engine with the engine
machinery space open while someone is in the
machinery space, either closed or open. Never
open the machinery space unless the engine is shut
off and the engines rotating parts are stationary.
Rotating machinery can cause injury and even death
if an accident should occur. Extreme care must be
exercised if a problem exists that requires operation
of the engine with the machinery space open.
IT IS
RECOMMENDED THAT UNCOVERED ENGINE
OPERATION BE ATTEMPTED BY TRAINED AND
QUALIFIED SERVICE PERSONNEL ONLY.
8. Check engine oil pressure immediately after
the engine starts. If oil pressure is not within
specifications (see Engine Specifications),
immediately stop the engine and determine the
cause.
9. Check voltmeter for proper charging system
operation.
10. Check the engine and transmission for fuel, oil,
water and exhaust leaks.
11. Allow the engine to reach normal operating
temperature. Check the temperature gauge
to ensure the engine is operating within the
normal temperature range. If the temperature
is abnormally high, stop the engine immediately
and determine the cause.
5. Do not pump or open the throttle when
starting the engine (Figure 5-3). The ECM
will automatically regulate the fuel and control
desired idle speed.
PCM has introduced a product enhancement feature on
all PCM Mulitport Fuel Injection Products. Your engine
may be equipped with the engine auto-crank feature.
This feature allows the engine to automatically crank,
or turn over, when commanded. Once the operator has
turned the key to the START position on a key switch, or
depressed the START button on a touchpad, the engine
will automatically turn over and start. The engine will turn
over until the engine starts, or a maximum of 5 seconds.
The key switch or stop button can always be utilized in
order to cease the engine from cranking and/or starting.
Important : In the event that the engine must be turned
over WITHOUT automatically cranking or starting (i.e.
bumping the engine to #1 position or performing a
compression check) a remote starter button MUST be
used, connected directly to the starter solenoid and the
ignition system disabled.
6. Turn the ignition key to the start position. When
the engine starts, release the key.
NOTICE:
Engine idle speed is controlled by the ECM
and is based on the operating temperature of the engine.
Upon initial start-up, engine RPM will be slightly higher
and will automatically decrease as the engine operating
temperature increases.
7.
In the event the engine becomes flooded,
ensure the Neutral Lockout is engaged and move
the throttle lever to a 100% open position (Figure
5-3). At this throttle position, the ECM will
command the injectors to deliver no fuel during
engine cranking. When the engine starts, return
the throttle lever back to the idle position.
NOTICE: Single lever throttle/shift handles use different
mechanisms to achieve Neutral Lockout or throttle only
operation. Some require you to push in on a button
while moving the handle forward, others require the
button to be pulled out. Refer to your boat owners
manual for complete instructions on throttle/shift lever
operation.
IMPORTANT: If the engine fails to start within 20-30
seconds, turn the ignition key to the OFF position
and allow 2 minutes for the starter motor to cool off
before attempting to restart the engine.
NOTICE:
If engine still fails to start, contact your PCM
Engines Dealer for service.
Figure 5-3
Typical Throttle / Shift Position Settings
NEUTRAL
FORWARD SHIFT
RANGE
IDLE IDLE
REVERSE SHIFT RANGE
FORWARD
THROTTLE
RANGE
REVERSE
THROTTLE
RANGE
NEUTRAL
LOCKOUT
SAFETY
COLLAR
FULL
THROTTLE
FULL
THROTTLE