© PCE Instruments
8.2
AV output
The AV output serves to transfer files to a television in standard definition. HD is not supported.
1. Connect the device to a TV using the AV cable.
2. Use and to switch between “NTSC” and “PAL” (depending on the TV).
3. Confirm with
.
4. You can leave the mode by pressing
.
9
Maintenance
9.1
Replacing the borescope cable
If a different cable needs to be installed to the borescope you can proceed as follows:
1. Switch off the device.
2. Loosen the cable from the device and pull it out carefully.
3. Insert the different borescope cable. Note that the pins have to be inserted correctly.
4. Tighten the sealing nut.
9.2
Firmware update
1. Switch off the device. Press and hold
and simultaneously to enter factory
mode.
2. After this, the firmware version will be displayed.
3. Copy the file of the new firmware to an SD card.
4. Insert that SD card into your borescope.
5. Press and
to turn on the device.
6. The update will be made automatically.
7. The instrument will switch off after the update.
