Address:East Room 306,3th Floor,1st Building,Shenhua Industrial Park,Meihua Road, Futian District,Shenzhen City
Tel:0755-32978297
Email:[email protected]
Manual
4.3.1
Signal strength (level)
In the middle of the display, a bar graph is displayed depending on the received signal strength. A
numerical value of the received signal strength in dB will also appear in the upper-left corner of the
display. The max. level to be displayed is 60 db.
4.3.2
Volume/ sensitivity
The selected volume/ sensitivity will appear on the right side in a bar with up to 16 steps.
4.3.3
Battery level
On the bottom left, a battery symbol is displayed with a battery level bar. The current battery voltage in
volts is also displayed below it.
4.4
Battery charging
The battery is charged within the device. For this, the supplied plug-in power supply is connected to the
built-in charging socket of the PCE-LDC 10 and the 230V socket.
If the battery is sufficiently charged, the status LED will flash green after the connection of the
power supply and no additional charging will be performed.
If the charge state of the battery is too low, the charging process will automatically start and the
LED will light up red. The charging is automatically discontinued after the battery reaches its full
capacity. The LED will then be permanently illuminated in green.
Comment:
During the charging, the unit will not be operational. Additionally, it cannot be switched on during the
charging process. A switched on device will automatically switch off if the power supply for the battery
charging is connected.
4.4.1
Deep discharge protection
The battery pack has a protection for deep discharge and turns off at 6V.
7
