Manual
5
5 Instructions
5.1 How to make a measurement
To make a measurement, simply target the lens (7) of thermometer at the object to be measured and
press the measurement key (6). The surface temperature will then be displayed. The distance-to-spot
–
ratio is 30:1. Please make sure that the target area is within the field of view.
5.2 Functions
Press the mode key (2) to see the following functions:
Here, you can see the emissivity. The default emissivity is 0.95.
Press the mode key (2), then press the up (4) or down key (3) to set the emissivity.
Press mode key (2) to confirm. You can select an emissivity between 0.10 (10 E) and
1 (100 E).
Press the mode key (2) to enter maximum (MAX), minimum (MIN), difference between
MAX and MIN (DIF) and average (AVG) modes. During measurement, the respective
reading will be displayed next to the mode icon.
Press the up (4) or down (3) key to change the high alarm (HAL) or low alarm (LAL).
Then press measurement key (6) to confirm your entry. When the reading exceeds the
high alarm (HAL) or falls below the low alarm (LAL), the high or low icon will flash and
you will hear a beep sound.
Use the thermocouple socket (5) to connect the probe. Target the object to be
measured with the probe. The thermometer will display the temperature automatically.
To see the maximum or minimum value during probe measurement, please press and
hold the up (4) or down key (3).
After measuring high temperatures, the probe may remain hot for a while.
5.3 Settings
In E, MAX, MIN, DIF, AVG modes:
Press the up key (4) to lock or unlock. Lock mode
is particularly useful for continuous temperature
measurements of up to 60 minutes.
Press the down key (3) to switch between °C and
°F.
In MAX, MIN mode: press and hold the
measurement key (6).
The bar indicator shows the
measured temperature. The bars
will be
RED
when the reading is
close to the maximum value or
BLUE
when it comes close to the
minimum value. They will be
YELLOW
when the temperature
is between the maximum and the
minimum value.
Backlight
The LCD backlight is always on.
In all modes: Press and hold the measurement key
(6).
Then press the down key (3) to turn the laser on or
off.
