© PCE Instruments
9
6.7.4
Key / control sounds
•
Navigate to the advanced settings as described above.
Press the "SET" key repeatedly until "bEEP" appears on the display.
•
Use the
"▼ / Power "or "▲ / Time" key to select yes or no.
•
Confirm the selection with the "LOG / Enter" key.
•
Press the "SET" key repeatedly until you return to measuring mode or wait for 5
seconds; then the meter will switch to measuring mode automatically.
6.7.5
Decimal character
•
Navigate to the advanced settings as described above.
Press the "SET" key repeatedly until "dEC" appears on the display.
•
Use the
"▼ / Power" or "▲ / Time" keys to select "Euro" or "USA".
"Euro" corresponds to the comma and "USA" corresponds to the dot. In Europe, the
comma is mainly used as the decimal character.
•
Confirm the selection with the "LOG / Enter" key.
•
Press the "SET" key repeatedly until you return to measuring mode or wait for 5
seconds; then the meter will switch to measuring mode automatically.
6.7.6
RS232 output
•
Navigate to the advanced settings as described above.
Press the "SET" key repeatedly until "rS232" appears on the display.
•
Use the
"▼ / Power" or "▲ / Time" key to select yes or no.
•
Confirm the selection with the "LOG / Enter" key.
•
Press the "SET" key repeatedly until you return to measuring mode or wait for 5
seconds; then the meter will switch to measuring mode automatically.
6.8
Measurement range
•
Navigate to the advanced settings as described above.
Press the "SET" key repeatedly until "rng" appears on the display.
•
Use the
"▼ / Power" or "▲ / Time" keys to select 300 mV or 3000 mV.
•
Confirm the selection with the "LOG / Enter" key.
•
Press the "SET" key repeatedly until you return to measuring mode or wait for 5
seconds; then the meter will switch to measuring mode automatically.
7
Battery replacement
•
Replace the batteries when the low battery indicator
appears in the left corner of
the display. Low batteries can lead to incorrect readings and loss of data.
•
Loosen the middle screw in the lower area on the back of the unit.
•
Open the battery compartment.
•
Remove the used batteries and insert 6 new 1.5 V AAA batteries correctly.
•
Close the battery compartment and fasten the locking screw.
