Manual
7
If you select the option, you have the following possibilities:
• Add Data: Press OK to go to the [Parameter] menu. There you can add data or change the parameters
for the test components.
• Del Component: deletes the current components
• Del All Component: deletes all of the components that are on the device
• Print: Prints the data of a component via a portable printer. Aim the infrared LPT of the device at the
infrared interface of the printer, which must be located within 0.8 meters. For larger distances printing
fails.
• Quit: back to the main menu
4.3.3 Settings
• Lower Limit: sets the lower limit for permissible values
• Higher Limit: sets the upper limit for permissible values
• Backlight: adjusts the screen brightness. Reducing the brightness prolongs the battery life
• Volume: adjusts the volume of the voice function. Reducing the volume extends the battery life
• Auto Off: Sets the auto power off after a prolonged disuse. This helps to preserve the batteries (this
setting does not take place while the device is in a recording mode)
• Sensor Adjust: If there are discrepancies between the digital and analog display, or when you have
replaced the mechanical parts, you should adjust the zero point. When you calibrate the steel anvil, you
can adjust the display value using the arrow keys till both values match. Then press "Safe" to save the
adjustment or press "Back" to cancel it.
• Setting Time: sets the time.
• Product Info: Here you can view the information about the device: device number, serial number,
inspection number, memory capacity etc.
