Working with control panel
12/29
display average of moisture content of the product based on four sample measure-
ments. After this the similar procedure can be performed for sensor
B
(fig. 9).
fig 9. Product moisture measured in “Laboratory” mode
In certain cases the number of measurements in
mode should be
increased for correct measurements. This is especially important for wet grain (more
than 18% for grain and leguminous products and more than 13% for oilseeds) be-
cause wide dispersion of moisture and density of samples is usually observed. For
example in order to obtain correct measurement results for wet corn the number of
measurements should be increased to 10.
In order to change the number of measurements press on the digit following
“
Number of measurements
” line and enter a new number using the appeared numer-
ic pad (fig. 10), confirm input by pressing
.
fig 10. Selecing number of measurements for “Laboratory” mode
After setting the number of measurements, press
button and perform
10 fillings to get the correct moisture content value.
