Install Memory
The mainboard has three DIMM slots which can be installed with
memory modules. You must install at least one memory module in
order to use the mainboard.
For this mainboard, you must use 168-pin, memory modules
installed with SDRAM/EDO/FP memory chips. The board
supports 3.3V memory and also 5V memory. You can select the
memory voltage by using the jumper JP8. See the next section for
information on using JP8.
If you are using a processor cartridge that runs on a 100 MHz
system bus, you must use memory that operates on a 100 MHz
memory bus (PC-100 memory). If you are using a processor
cartridge that runs on a 66 MHz system bus, you can use memory
that operates on a 66 MHz memory bus. You can install any size of
memory module from 16 MB up to 256 MB, so the maximum
memory size is 3 x 256 MB = 768 MB.
The edge connectors on the memory modules have cut outs, which
coincide with struts in the DIMM slots, so the memory modules
can only be installed in the correct way.
On the DIMM slot, pull the locking latches at either end of the
slots outwards. Position the memory module correctly and insert it
into the DIMM slot. Press the module down into the slot so that the
locking latches lever inwards and lock the module in place.
DIMM3
DIMM2
DIMM1
Содержание M726MRT
Страница 48: ......