6
Wiring Harness
Figure 2: Wiring Harness
1
2
3
4
To Pump Motor
Installation
Wiring Harness
Ref #
Qty.
Part Number
Description
1
1
--
Motor Plug End
2
1
SPT-SWH-9615A-16G Harness, Wiring 8 Ft w/ Switch
3
1
SPT-BCG-1215A-16G Harness, Battery Connector w/15A Fuse
4
1
ATC-15
Fuse, 15 Amp Buss
1. The wiring harness needs to be connected to a DC
power source (vehicle battery) or a power access
point providing at least 12 volts & 10 amps of current
to the ring terminals on the fuse harness (3) (Figure
2). NOTE: Make sure that the selected power source
provides the adequate power requirements as stated
above. Inadequate power can cause problems and
performance issues with the pump.
2. Connect the red wire to the positive terminal on the
vehicle’s battery or other alternate power source
positive terminal. Proceed to connect the black wire
to the negative terminal of the vehicle’s battery or a
good ground source. NOTE: The fused wire harness (3)
(Figure 2) can be unplugged from the switch harness
(2) (Figure 2) and be left attached to the battery or
power source for convenience purposes.
3. Mount the switch (2) (Figure 2) in a location that is easily accessible for operation on the vehicle. Make sure to secure the switch
so that it cannot fall out of place or become entangled and cause damage. NOTE: Use caution when routing the wiring harness
to avoid areas where the wires could become pinched, rubbed, or exposed to excessive heat.
Mounting the Skid Sprayer
It is recommended to use straps (1) to secure the sprayer to
the utility vehicle’s bed, as shown (Figure 1).
•
There are two different mounting positions for the
boom mounts (Item 2) to allow for different bed
lengths.
•
The boom (Item 3) can be bolted at different heights to
have the spray height hold out to as close to 20 inches
as possible from the tip to the ground.
Figure 1: Skid Sprayer Mounting
3
2
1
