5 of 6
www.pbteen.com
Assembly:
1. On a soft, scratch-free surface, such as a carpet or rug, remove the hutch from box.
2. Using wooden knob hardware pack, carefully attach a Wooden knob (B) to a door, holding the knob over
pre-drilled hole in door front. Screw a Wooden knob bolt (A) through the rear of the door so that it enters the
Wooden knob (B), using Phillips screwdriver. Tighten and repeat with remaining door.
3. Two adults should lift the hutch up, and carefully place it on the desktop, as shown.
4. Using the Mending plates (C) and Phillips head screws (D), affix the back of the hutch and the desktop.
Align the Mending plate over the pre-drilled holes in the hutch, using a Phillips Head Screwdriver, and insert
the Phillips Head screws (D) through the Mending plate into the hutch and desk top, tightening with the
Phillips Screwdriver. Do not fully tighten until all screws are in place. Failure to do so may cause the parts
to misalign. Repeat on other side of hutch and fully tighten all screws. For assembly of the entire desk,
please refer to the assembly instruction for the desk.
