Page
1
re
da
e
R
:
n
oi
t
ua
C
yl
no
sr
ed
ae
r
C
D
V2
1
ro
F
+V out
Red LED
Amber LED
Green LED
Data/D0
Clock/D1
Media Detect
0V
Entry
12V
12V Lock
0V
0V
N.C.
N.O.
COM
Alarm
12V
Green LED
Exit
0V
Contact
0V
0V
Tamper
PSU
0V
no
tt
u
B
ti
xE
yal
e
R
kc
oL
st
up
tu
O
st
up
nI
re
wo
P
tc
at
no
C
re
p
ma
T/
U
SP
Net2 nano
Ins-40075-US Net2 nano control unit - UL
Exit button
(push to make)
Reader/keypad
Tamper switch
Door contact switch
(held closed by door)
01/28/2013
12V DC
power supply
This is the heartbeat of the
system and should pulse
regularly. This indicates that
the processor is functioning.
Net2Air wireless activity (Tx/Rx) - Blue
12V
(Green) - Power LED.
Lock
(Orange) - The 12V lock output is energised.
Relay
(Orange) - The relay is energised - (NO/COM contacts are closed).
Alarm
(Red) - 12V Alarm output is active.
Exit
(Orange) - The exit button contacts are closed.
Contact
(Orange) - The door contacts are closed.
Tamper
(Orange) - The tamper contacts are closed.
PSU
(Orange) - The PSU contacts are closed.
Net2Air
(Blue) - Net2Air interface Tx/Rx activity.
OK
(Green flash) - The internal software is running.
LED indications
This access control unit uses wireless communication. It is recommended that a Net2Air
site surveyor is used to determine the best position for the bridge and control units.
Diagnostic LEDs
This wireless unit requires a Net2Air bridge to communicate with the server PC.
*
Not connected
*
Lock release
A new unit requires approximately 30 seconds after initial power up to self configure.
During this time the OK LED will not be flashing.
The unit will not operate correctly until this function has completed.
Paxton
Technical Support
Technical help is available: Monday - Friday from 02:00 AM - 8:00 PM (EST)
1.800.672.7298
Documentation on all Paxton products can be found on our web site - http://www.paxton-access.com/
For instructions in alternative languages - http://paxton.info/1000
