ins-01029
Paxton10 Door controller- 010-052, 010-403, 010-751
The following warnings and instructions MUST be adhered to. Read the instructions before installing and
powering the equipment. Keep the instructions in a safe place for future reference.
INSTALLATION - 010-751
Only qualified and trained personnel, familiar with this type of product and who fully understand these
instructions should install, connect or test this equipment. There are no user serviceable parts
within the PSU unit.
•
The equipment is intended for indoor use only in dry locations. This is a Class A product. In a
domestic environment this product may cause radio interference in which case the user may
be required to take adequate measures.
•
The installation must meet National Wiring Regulations and IEC62368-1 standards.
•
Disconnect devices: A readily accessible disconnect device shall be incorporated in the
building wiring to include an appropriately rated circuit breaker to disconnect both poles
with at least a 3.0 mm contact gap. After switch off, all internal capacitors will discharge to
safe levels within 60 seconds under normal conditions. Under fault conditions, charge may be
held for much longer and suitable precautions should be taken before handling the unit.
•
If fitted, disconnect battery to fully isolate the unit.
•
Protection device: The fusing characteristics of the protection device to be used are T3.15AH250V
BATTERY SAFETY WARNING - 010-052, 010-403, 010-751
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
12v DC 7Ah LEAD ACID BATTERY.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
If a back-up battery is fitted it must be:
a) A 12Vdc, 7Ah lead acid valve regulated battery.
b) Specified to be charged up a temperature of 50°C and discharged at a temperature up to 60°C.
c) A maximum weight of 2.5kg.
d) Capable of being fitted and secured in the space provided.
e) Third party tested by an accredited laboratory to meet the requirements of IEC 62368-1: 2014, Annex M.
Paxton10 Video controller- 010-187, 010-907
The following warnings and instructions MUST be adhered to. Read the instructions before installing and
powering the equipment. Keep the instructions in a safe place for future reference.
INSTALLATION - 010-187
Only qualified and trained personnel, familiar with this type of product and who fully understand these
instructions should install, connect or test this equipment. There are no user serviceable parts
within the PSU unit.
