Page 16
SETTING
GENERAL dATA
All functions of the DAT 500 are activated and modified by accessing a simple setup menu, shown on
the next page. All settings selected or activated remain stored even after switching off the transmitter.
The DAT 500 is preconfigured with a default setting. The following pages show the values of “Default”
for each parameter.
With the first on-site installation, it’s necessary to change some parameters in order to obtain a correct
indication of the displayed weight (Theoretical adjustment).
This may be required when you purchase the DAT 500.
The settings of the setup menu can be changed using the front keys or via the utility “INOVATION”
software supplied.
CHANGING ANd ENTERING THE PARAMETERS:
The setup parameters are grouped into a number of main menus.
To access the setup menu press the
PRG
key and then the
SET
key and hold down simultaneously
for 3 seconds.
The display shows the message
Conf1G
that is the first of the main menus
Use the arrow keys to select the menu you want to change.
Press the
PRG
key to access the selected menu.
KEY
FUNCTION dURING THE MAIN MENU PROGRAMMING
SET
It selects the next menu.
FUN
It selects the previous menu.
0
It exits the programming menu or returns to the upper level.
PRG
It accesses the corresponding sub-menu or programming or confirms the selected
parameter.
KEY
FUNCTION WHEN SETTING THE NUMERICAL VALUES
SET
It increases the value of the flashing digit.
FUN
It decreases the value of the flashing digit.
0
It goes to the next digit.
PRG
It confirms and store the displayed value.
