Paul Agnew Ilektro 1250L, Инструкции пользователя и установка

Страница: 13 / 40

1
3
THERMAL SAFETY CUT OUT
IF THE SAFETY CUT OUT FOR THE HEATER
TRIPS THE APPLIANCE HAS OVERHEATED.
IF THIS HAPPENS:
•
SWITH OFF
THE DEVICE
FROM THE
ISOLATION SWITCH
AND ALLOW IT TO
COOL DOWN FOR A MINIMUM OF 2 HOURS
• CHECK THE HEATER OUTLET VENTS FOR
ANY OBSTRUCTION AND CLEAR IF
NECESSARY. SEE MAINTENANCE SECTION
FOR GUIDANCE
• PLUG IN THE APPLIANCE AND SWITCH IT ON.
THE CUT OUT WILL RESET AND THE
APPLIANCE SHOULD FUNCTION NORMALLY.
• IF THE APPLIANCE CONTINUES TO NOT
FUNCTION CORRECTLY, CONTACT THE
RETAILER OR PLACE OF PURCHASE.
THE AIR INLET GRILLES ON THE
TOP
SIDE
AND BACK OF THE APPLIANCE SHOULD BE
UNOBSTRUCTED. FREE AIR NEEDS TO
CIRCULATE IN THIS AREA.
ALWAYS
SWITCH OFF
THE APPLIANCE
FROM THE
ISOLATION SWITCH
BEFORE
CLEANING OR UNDERTAKING AND
MAINTENANCE.
GENERAL CLEANING
• ONLY CLEAN THE GLASS WHEN ITS COLD
• DO NOT USE ABRASIVE CLEANERS ON ANY
PART OF THE APPLIANCE
• USE A LINT FREE CLOTH TO WIPE ANY
SURFACES
• DO NOT SPRAY CLEANER INTO THE
APPLIANCE
CLEANING THE FUEL BED
TO ACCESS THE FUEL EFFECT IT WILL BE
NECESSARY TO REMOVE THE FRONT GLASS
VIEWING PANEL, SEE SERVICING SECTION
• ENSURE THE APPLIANCE IS
SWITCHED OFF
AT ISOLATION SWITCH.
• REMOVE THE LOGS AND DUST CLEAN. DO
NOT WET THE LOGS.
• USE A LINT FREE DUSTER.
• LIFT ALL FUEL MEDIUM OUT OF THE FIRE
AND WIPE FUEL BED DOWN.
• ENSURE NO MOISTURE REMAINS BEFORE
RETURNING THE LOGS INTO POSITION. SEE
LOG INSTALLATION PROCESS.
• CAUTION: REPLACE FRONT TRIM WHILE
REMOVING LOGS AND FUEL MATERIAL TO
ENSURE PIECES DO NOT FALL INTO THE
APPLIANCE
• REPLACE THE GLASS AND TRIM AS
DESCRIBED IN THE
SERVICING INSTRUCTION
SECTION.
HOW TO USE YOUR APPLIANCE
4. OPERATING INSTRUCTIONS
HOW TO USE YOUR APPLIANCE
5. MAINTENANCE AND CARE