
7
First you’ll need to nock out the plywood opening the canister tunnel. Use a hobby knife on the small
area not cut with a laser and lightly tap it out with a small hammer.
Install the landing gear to the fuselage using the four 8/32 bolts, spring washers, and flat washers, and
compression nuts.
Now lets get the tail wheel assembly installed.
Once the mains are on, find the holes for the tail wheel assembly and open.
Once the mains are on, find the pre-marked holes for the tail wheel assembly and drill out for 6/32
bolts. Install assembly using loc-tite.
Install the steel tiller horn just behind the hinge line on the bottom of the rudder using the two small
wood screws.
Tip#2 Set aside your two tiller springs, we will install those later after the rudder is mounted
.