6
First you’ll need to nock out the plywood opening the canister tunnel. Use a hobby knife on the small
area not cut with a laser and lightly tap it out with a small hammer.
Install the landing gear to the fuselage using the four 8/32 bolts, spring washers, and flat washers, and
compression nuts.
Now let’s get the tail wheel assembly installed.
Once the mains are on, find the pre-drilled hole for the tail wheel assembly. Insert the tail wheel
assembly and lightly tap in flush with a small hammer.
Next, mark the hold down locations, drill and mount them with the four wood screws securing the tail
wheel assembly. Remove the wood screws and coat the holes with thin CA, let dry, reinstall.
Install the steel tiller horn just behind the hinge line on the bottom of the rudder using the two small
wood screws.
Tip#2 Set aside your two tiller springs, we will install those later after the rudder is mounted.
