Installing the rack ears
69
SmartNode 5540E & 4140E Series User Manual
G
• Installing Optional Rack Ears
Installing the rack ears
Do the following:
1.
While holding the rack ear in place where shown in
, use a cross-tip screwdriver to install three
mounting screws (included with the rack ears kit) to secure the rack ear.
2.
Repeat step 1 to install the remaining rack ear on the other side of the device.
Figure 25. Connecting the 552-GS2 to a CL1300R
3.
Install the device in a 9-inch rack
using mounting screws (not supplied).
Congratulations! The rack ears are installed.
If you have a DIN rail mounting clip to install, go to Appendix H,
“Installing Optional DIN Rail Mounting
on page 70. Otherwise, go to section
Содержание SmartNode 5540E Series
Страница 54: ...54 Appendix C Cabling Chapter contents Introduction 55 Ethernet 55 Analog FXS 56 Analog FXO 57...
Страница 58: ...58 Appendix D Port pin outs Chapter contents Introduction 59 Ethernet 59 FXS port 59 FXO port 60...
Страница 61: ...61 Appendix E SmartNode Device Factory Configuration Chapter contents Introduction 62...
Страница 68: ...68 Appendix G Installing Optional Rack Ears Chapter contents Installing the rack ears 69...
