Patton CopperLink CL1211E, Руководство пользователя

Страница: 23 / 48

Connecting the Line Interface 23
CopperLink CL1211E/CL1212E User Manual 2 • Installation
5.
Place the CL1200E at the desired location, and install it using hardware appropriate for the type of mount-
ing surface.
The mounting ears have been installed on the CL1200E; proceed to section “Connecting the Line Interface”
on page 23.
Installing the Mounting Plate Installation Kit (INS-KIT-MNTPLATE)
Do the following to install the mounting plate installation kit:
1.
Using a cross-tip screwdriver, remove the four screws from the rear panel of the CL1200E as shown in
(
figure 3 on page 18).
Figure 11. Installing the mounting plate
2.
Install the mounting plate onto the CL1200E enclosure using the screws removed in step 1 as shown in
figure 11 .
3.
Place the CL1200E at the desired location, and install it using hardware appropriate for the type of mount-
ing surface.
The mounting plate has been installed on the CL1200E; proceed to section “Connecting the Line Interface”
on page 23.
Connecting the Line Interface
The CL1200E supports communication between two peer Ethernet LAN devices over a distance of up to 3300
ft (1 km) over 24 AWG (0.5 mm) twisted-pair wire, Cat5+, or 75-ohm BNC. The CL1200E will be equipped
with one of the following interfaces:
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION