Installing the gateway router
25
SmartNode 4552 & 4562 Getting Started Guide
3 • SmartNode installation
Installing cables
Connect the cables in the following order:
1.
Connect the ISDN terminals and NT to the BRI ports (see section
“Connecting ISDN terminals and NT
to the SmartNode’s ISDN BRI ports”
).
2.
Connect the 10/100Base-T Ethernet LAN and WAN (see section
“Connecting the 10/100Base-T Ether-
net LAN and WAN cables”
on page 25)
3.
Connect the power supply (see section
“Connecting the power supply”
on page 26)
Connecting ISDN terminals and NT to the SmartNode’s ISDN BRI ports
The SmartNode comes with two ISDN BRI ports located on the rear panel (see
figure 2
on page 15). Install the
cables as follows:
1.
Connect a cable between port
BRI 0/0 (Line)
of the Model 4552 and the S/T outlet of the ISDN NT.
2.
Connect a cable between port
BRI 0/1 (Phone)
of the Model 4552 and the ISDN terminal (phone or PBX)
Note
If there is no ISDN network termination in the installation and you require S-
Bus line power for the connected terminals, you can install an S-Bus Phantom
Power Supply on port BRI 0/0 (Patton part number
SN-PM-BRI-
EXT/230/EU
). The SmartNode does not require S-bus line power to function.
For details on the BRI port pinout and ISDN cables, refer to
Appendix C, “Cabling”
on page 47 and
Appendix
D, “Port pin-outs”
on page 50.
Connecting the 10/100Base-T Ethernet LAN and WAN cables
The SmartNode 4552 & 4562 has automatic MDX (auto-crossover) detection and configuration on all Ether-
net ports. Any of the ports can be connected to a host or hub/switch with a straight-through wired cable.
1.
Connect port ETH 0/0 to the subscriber port of the broadband access modem (DSL, cable, WLL).
2.
Connect Ethernet ports 1 to 4 to your LAN devices (PC, printer, switches, etc.)
For details on the Ethernet port pinout and cables, refer to
Appendix C, “Cabling”
on page 47 and
Appendix
D, “Port pin-outs”
on page 50.
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
Содержание SMARTNODE 4552
Страница 17: ...SmartNode 4552 4562 overview 17 SmartNode 4552 4562 Getting Started Guide 1 General information ...
Страница 18: ...SmartNode 4552 4562 overview 18 SmartNode 4552 4562 Getting Started Guide 1 General information ...
Страница 47: ...47 Appendix C Cabling Chapter contents Introduction 48 Ethernet 48 ISDN BRI 49 ...
Страница 53: ...53 Appendix E SmartNode 4552 4562 factory configuration Chapter contents Introduction 54 ...
