Connecting cables
103
SmartNode 1000 and 2000 Series Getting Started Guide
7 • SmartNode 2400 installation
Figure 69. SmartNode 2400 connectors
Connecting cables
Installing SmartNode 2400 cables takes place in the following order:
1. Installing the 10Base-T or 100Base-T Ethernet cables into ports ETH 0/1 and ETH 0/0 (see
figure 69
) (see
“Installing the Ethernet cables”
on page 104).
2. Installing the interface card cables (see section
“Installing the interface card cables”
on page 105).
3. Connecting to a power source (see section
“Connecting to an external power source”
on page 110).
Do not work on the system or connect or disconnect cables during periods of
lightning activity.
The
Interconnecting
cables must be acceptable for external use
and must be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
100–240 VAC
50/60 Hz
power connector
36–72 VDC
1 Amp
Terminal block
AC power version
DC power version
(Model SN2400/48 only)
SLOT
4
ETH 0/1
10/100Base-T port
SLOT
3
ETH 0/0
10/100Base-T port
SLOT
2
CONSOLE
RS-232 port
SLOT
1
WARNING
CAUTION
