![background image](http://html2.mh-extra.com/html/patton-electronics/rocketlink-g-3088-i/rocketlink-g-3088-i_getting-started-manual_4097022020.webp)
Configure the IP address
20
3088/I Getting Started Guide
2 • Initial Configuration
Connect the G.SHDSL port
3.
Obtain single-twisted-pair cable with an RJ-11 plug connector at each end.
4.
Plug one end of the cable into the (yellow) RJ-11 socket (labelled
Line)
on the G.SHDSL NTU.
(See
figure 6
.)
5.
Plug the other end of the cable into the RJ-11 wall socket that provides your G.SHDSL service.
6.
Go to
G.SHDSL > Configuration
to configure the DSL port parameters.
Note
If two G.SHDSL NTUs are connected back-to-back, one must be config-
ured as
Remote
, the other as
Central
.
7.
The
WAN Link
LED will flash while in the process of establishing a link. The LED will be on constantly
once a valid DSL connection is established.
Figure 6. Rear view of LB510A showing DSL RJ-11 jack
MDI-X
Line
Ethernet
Power
Console
Содержание RocketLink-G 3088/I
