Patton electronics RocketLink-G 3088/I, Руководство по началу работы

Страница: 18 / 61

Configure the IP address 18
3088/I Getting Started Guide 2 • Initial Configuration
Connect a PC and log in
Using the included combination RS-232/Ethernet cable and DB9-RJ45 adapter, connect a PC’s serial port to
the NTU ’s
Console port (red outline) (see figure 3 ).
Figure 3. Connecting G.SHDSL NTU to the PC’s serial port
1. Start a HyperTerminal session on the PC using the settings:
9600 bps, 8 data bits, no parity, 1 stop bit, no flow control
2. Log in to the G.SHDSL NTU using the factory-default login ( superuser ) and password ( superuser ):
Login:
superuser
Password: *********
Login successful
Modify the IP address
1. Display current IP interface settings for the NTU Ethernet LAN port.
ip list interfaces <enter>
IP Interfaces:
ID | Name | IP Address | DHCP | Transport
—-|———|————————|—————|———————
1 | ip1 | 192.168.200.10 | disabled | <BRIDGE>
———————————————————————
———
2. Modify the IP address for the LAN port according to your network requirements.
ip set interface ip1 ipaddress 10.10.4.10 255.255.255.0
Note The above IP address (10.10.4.10/24) is only an example. You must choose
an IP address on the same subnet as your PC
.
3. Verify the new address is correct and save it in system boot memory.
fi
ip list interfaces <enter>
fi
system config save <enter>
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION
MDI-X
Line
Ethernet
Power
Console
Connect to Console port
Serial port
PC with
terminal emulator