NanoServ™
Thin System/Ultra-Thin System
Setup Guide
1.0 What’s included with the NanoServ™
The following items are included with the NanoServ™:
1.
NanoServ™
2.
AC Power Adaptor
3.
CD-ROM with User’s Manual
4.
This Setup Guide
Note
Refer to the User Manual on the CD-ROM for complete information on installation.
2.0 Steps for setting up the NanoServ™
Note
This is a fanless system, so it must be properly mounted to allow for proper cooling. Be sure to use the
metal stand to hold the system upright with the blue LED on top, or mount the system at least 1 or 2
inches away from the flat side surfaces of the system. This will help keep the NanoServ™ cool and
within operating limits.
1.
Verify that the power supply switch is off (located on the back of the NanoServ™).
2.
Plug the monitor into the VGA port.
3.
Plug the keyboard into the PS/2 keyboard port.
4.
Plug the mouse into the PS/2 mouse port.
5.
Plug the printer into the DB-25 printer port (only available on the Thin NanoServ™ system).
6.
Connect the power adaptor to the mains power.
7.
Turn on the power supply switch located on the back of the NanoServ™.
Document Number: 09407U7-001, Rev. A
Part Number: 07M6070-QS
Revised:
August 2, 2006
Sales Office: +1 (301) 975-1000
Technical Support: +1 (301) 975-1007
E-mail: [email protected]
WWW: www.patton.com
