Installing the IpLink 2888
26
IpLink 2888 Getting Started Guide
3 • IpLink installation
External AC Power Supply.
1.
Insert the barrel type connector end of the AC power cord into the external power supply connector (see
figure 7
).
2.
Insert the female end of the power cord into the internal power supply connector.
Figure 7. Power connector location on rear panel
3.
Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to chapter 5,
“Contacting Patton for assistance”
on page 32 to find out how to replace it with a com-
patible power cord.
4.
Connect the male end of the power cord to an appropriate power outlet.
5.
Verify that the green
Power
LED is lit (see
figure 6
).
•
Do not connect power to the AC Mains at this time.
•
The external power adapter shall be a listed Limited Power
Source.
•
The 2888 external power supply automatically adjusts to
accept an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
CAUTION
WARNING
RS-232
Console
Reset
3
2
1
0
T1/E1
Power
T1/E1
Ports 0-3
Console
RS-232 port
ETH 0
10/100/1000Base-T port
ETH 1
10/100/1000Base-T port
RESET
button
12V
, 1.25A
–
+
1
0
ETH
Содержание 2888
Страница 19: ...19 Chapter 2 Applications overview Chapter contents Typical IPLink 2888 Application 20...
Страница 41: ...41 Appendix C Cabling Chapter contents Introduction 42 Console 42 Ethernet 43 E1 Port 44 T1 Port 45...
Страница 46: ...46 Appendix D Port pin outs Chapter contents Introduction 47 Console port 47 Ethernet 48 T1 E1 port 48...
