7
3.0 CONFIGURATION
The 2707RC features configuration capability via hardware DIP switches
or SNMP through Patton’s Model 1001MC Management Card. This sec-
tion describes all possible hardware and software switch configurations
of the network connection.
Note
The 2707RC factory default is set to DIP switch control. Soft-
ware control can be enabled by setting S3 to a valid address
SNMP management station. Performing a hardware reset sets
the unit for dip switch control.
3.1 DIP SWITCH CONFIGURATION
The Model 2707RC has two eight bit DIP switches that allow configura-
tion for a wide range of applications. The switches are accessed by
removing the card from the chassis.Figure 1 shows the location of the
DIP switches on the top of the printed circuit board.
Figure 1.
Model 2707RC Series top view, showing location of DIP switches.
DIP Switches S1 and S3 can be configured as either “On” or “Off”.
Figure 2 shows the orientation of the DIP switches with respect to ON/
OFF positions. Default position and descriptions for Switches S1 and S3
are provided on the next page.
S3
S1
1
2
3
4
5
6
7
8
ON
1
2
3
4
5
6
7
8
ON
