14
SW1-1 Octet Function.
This switch determines whether the modem will
be set for clear channel mode or Octet timing. The 1082/F can be used
with either another 1082/F, a 1092A/F or a 1092ARC/C/OO modem from
Patton. However, when used in Octet timing mode, the 1082/F must be
used with another 1082/F.
SW1-2 Hardware/Software.
When the Model 1082/F is placed into
SNMP mode (switch SW1-4) the modem must be set to determine what
will control the modem. When configured for hardware control, the
1082/F can be viewed through SNMP, but changes can only be made via
hardware. When configured for software control, changes can be made
remotely via SNMP software.
SW1-3 Front Panel Switch Function.
This switch is used to enable or
disable the functionality of the front panel switches on the 1082/F.
SW1-4 SNMP Control.
This switch is used to allow the 1082 modem to
be controlled via SNMP when used as the remote CPE modem with a
1092ARC and a 1001MC management card.
SW1-5 Reserved .
This switch is reserved for internal factory use only
and should be set to the default position of OFF.
OFF
Octet Aligned
ON
Clear Channel
OFF
Hardware Control (DEFAULT)
ON
Software Control
OFF
Front panel SWs enabled (DEFAULT)
ON
Front panel SWs disabled
OFF
Reserved
ON
SNMP control enabled
