2. Strip the outer insulation from the twisted pair about one inch
from the end.
3. Strip back the insulation on each of the two wires about .25",
4.
Insert into the proper terminal post and tighten the screw. Be
sure that all cabling between the short range modems is
straight through.
Signal (S)
Signal (S)
Ground (G)
Ground (G)
NOTE:
Depending on version, terminal post locations may
vary.
5. Place the 2 halves of the strain relief assembly on either side
of the telephone wire and press together very lightly. Slide the
assembly so that it is about 2 inches from the terminal posts
and press together firmly.
7
6. Insert the strain relief assembly with the wire going through it
into the slot in the bottom half of the modem case and seat it
into the recess in the case. (If the telephone wire is too thin to
be held by the strain relief assembly, use tape to increase its
diameter. If the wire is too large, it may be necessary to drill
out the strain relief slightly.
6. BEND the top half of the case as necessary to place it over
the strain relief assembly. Do not snap the case together yet.
7. Insert one captive screw through a saddle washer and then
insert the captive screw with the washer on it, through the hole
in the DB-25 end of the case. Snap that side of the case
closed. Repeat the process for the other side. This completes
the installation process.
8
