EN
139
Using the tool
1.
To switch on the tool, press the on / off
switch
8
. The deeper the on / off switch
8
is pressed, the faster the rotary hammer
rotates.
2.
Make sure your workpiece can not slip.
Start working, while holding the tool
firmly.
3.
To switch off the tool, release the on / off
switch
8
.
Intended Use
The tool is intended for drilling in wood, metal
and plastic.
The tool is not intended for commercial use.
Any other use or modification to the tool is
considered as improper use and could cause
considerable dangers.
Product overview
1
Locking sleeve
2
Chuck
3
Hammer drill/ drill switch
4
LED light
5
Battery release switch
6
Battery (not included)
7
Soft grip
8
On / Off switch
9
Rotation direction switch
10
Locking button for Hammer drill/ drill
switch
Warning!
If the rotary hammer is
not in use, centre the rotation direc-
tion switch in order to lock the rotary ham-
mer.
Slide the battery (not included) onto
the charger and check its LED:
Red:
Charging
Green:
Battery is fully charged
Flashing Red:
Battery is defective
Flashing Green:
Battery is too hot/ cold
2
CHARGER SET-UP
Plug the charger (not included) into a
suitable wall socket.
1
Caution!
Only use the provided bat-
tery adaptor in order to charge the
battery.
Overload protection
When the load is too high or the allowable
battery temperature is exceeded, the motor
comes to a stop. Relieve the load on the ma-
chine immediately and allow cooling for ap-
prox. 2-3 min at the highest no-load speed to
cool-down the motor.
1
2
1
9
2
3
4
5
8
6
7
10
