EN
88
EN
89
FASTENING THE HOIST TO THE LOAD
Altach the Ioad hook
10
, which is fas-
tened to the wire cable
8
by the guide
roller
9
, securely to the Ioad you intend
to pull. Check that the snap lock
6
is
closed.
1
Push the tensioning spring
2
up and
into the release position, which re-
leases the retaining catch
3
from the
pulley
4
.
2
3
By holding the stop lever
5
in the re-
leased position, the cable can be un-
wound and the hoist can be pulled.
Pull the hoist to the second attachment
point and attach with the fastening
hook
7
.
Hold the stop lever
5
in this position
with your finger and release the clamp-
ing lever
1
again.
3
Releasing the clamping lever
1
slack-
ens the wire cable
8
. You can now re-
lease the load hook
10
and the fasten-
ing hook
7
and remove the wire rope
puller.
4
PULLING A LOAD
Push the tensioning spring
2
down and
into the pull position, which engages
the retaining catch
3
in the pulley
4
again.
Warning!
Only pull loads horizon-
tally.
1
Now move the hand lever
1
using
pumping movements. This rewinds the
wire cable
8
onto the pulley
4
again and
pulls the load to the desi red position.
2
SLACKENING/RELEASING THE HOIST
Make sure that the load is fastened
securely to prevent it being released
unintentionally. To release the hoist,
push the tensioning spring
2
upwards
to release the retaining catch
3
.
Warning!
lt is possible for the load
to be re leased abruptly!
1
Push the clamping lever
1
forward
completely, the stop lever
5
is pushed
upward.
2
4
3
1
2
2
1
4
3
2
1
4
2.
2.
2.
2.
1.
1.
1.
1.
