4
Instructions for PE5B and PE10B
Installation and operation - DC 6 V/12 V battery connection
1
The unit can be mounted directly onto a steel T-post or Y-post using the
mounting slot in the case rear. Alternatively, the unit can be mounted onto a
wooden post, another suitable vertical support or suitable wall material
using a 3” (75 mm) flat headed nail. Hammer in the nail, allowing it to
protrude by 3/8” (10 mm). Slide the unit onto the nail with the nail inside
the mounting hole on the back of the unit.
2
Connect the Fence ground terminal (green) to a separate ground system that
is at least 33’ (10 m) away from other ground systems.
3
Connect the Fence output terminal (red) to the fence.
4
Connect the unit to a 6 V/12 V battery using the battery leads. Attach the +
(red) clip to the positive terminal of the battery, and the – (black) clip to its
negative terminal.
The pulse indicator light
flashes each time the unit
pulses.
5
To prevent damage caused
by stock interference and
bad weather, house the
battery and the unit in
protective enclosures.
Note:
If the unit is being mounted on a wall made of concrete, brick, plasterboard
or similar, use a screw instead of a nail. A wall anchor or plug may also be
required.
Caution!
When connecting the battery, be careful not to short-circuit the
supply terminals.
The linked image cannot be displayed. The file may have been moved, renamed, or deleted. Verify that the link points to the correct
file and location.