STEP 5
Befor
e plugging in, always be sure the
switch on the motor is in the OFF posi-
tion.
Use up to 100 feet of 12 gauge,
outdoor-approved extension cord.
Plug into a 15 amp, ground-fault-
equipped outlet.
W
ARNING: BE SURE THE
SWITCH IS OFF BEFORE
PLUGGING IN THE CORD.
Now check all the fasteners. They may have loosened during shipping.
Tighten anything that’s loose. It’s a good idea to check the fasteners for tight-
ness before every use.
Cords &
Circuits
For safety and maximum performance, use only the cor
ds specified and run
the machine on circuits as we have described.
A word about the ON/OFF switch:
To turn the power off, move the switch to OFF. Notice, we don’t say “to
stop the chipper-shredder-vac.” Inertia causes the rotor to coast, even after the
power is shut off. Don’t mess with a moving rotor!
For your personal safety, please remember to follow the Shut Down
Procedure before attempting to service or clean out your chipper-shredder-vac
in any way. Turn off the motor. Disconnect the plug from the receptacle. Wait
until all moving parts have stopped.
For your safety and satisfaction, keep the motor fan’s air intake free of
accumulations of dust, dirt and leaves. An authorized Patriot service center
can help you should problems arise.
K
eep a wide
stance and
gently push
and fold
bushy debris
into the
cone.
▲
!
page 9
GFI-
equipped
outlet
12 gauge
cord with three-
pronged plugs
15 amp
circuit
100’
cord
max.
Overhead view of the cord,
outlet and circuit.
