Page 2 of 4
191106
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
ASSEMBLY INSTRUCTIONS
PREPARATION
Turn off the power at fuse or circuit box.
WARNING
●
Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
●
Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
●
All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
●
Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
●
Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
●
If a dimmer control switch is used with this fixture, obtain professional advice to determine the correct type and
electrical rating required.
1. Remove the collar from the
mounting strap unit (AA).
Attach the mounting strap
unit (AA) to outlet box using
two mounting screws (BB).
2. Take the glass shade (C) out
from the frame (B) carefully,
then discard the bubble bags
and foams.
AA
BB
1
1
Collar
2
C
B
3. Unscrew the set screws
from the frame (B). Put the
glass shade (C) into the
frame (B) carefully, then
secure it with the clips (GG)
and set screws.
3
GG
C
B
Set Screw
