Stationary and Rolling Supports
NOTE: There must be no more than a 16 ft. span between supports!
For stationary post supports, loosen
set screws on Post Bracket and insert
pipe. Add Foot Plate base and Pipe
Cap then set to desired height and
tighten set screws on Post Bracket.
Be sure to level the dock to complete
the installation process.
For stationary Screw Jack supports, assemble
the Drop Leg base by inserting vertical tube
into the flat base and install 1/2” bolt. Insert
vertical tube into Screw Jack opening, set
height and install 1/2” bolt.
To install the Jack Axle attachment, slide
Jack Axle over traveling tube of the Screw
Jack and install 1/2” bolt.
Install wheel onto Jack Axle and secure in
place.
NOTE: Drop Leg components are
not used in conjunction with the Jack Axle
attachment.
Wheels are orientated outward on 4 ft. wide docks.
Wheels are oriented inward on 8 ft. wide docks.
For pipe axle assembly,
install Axle Converter
pieces to a set of vertical
support pipes (the shorter,
closed off leg of Axle
Converter receives the ver-
tical pipe). Install axle pipe
(6 ft. pipe used with 4 ft.
wide docks and 8 ft. pipe
used with 8 ft. wide docks)
through the horizontal leg
of the Axle Converter pair.
Add wheels and secure in
place with Wheel Stop
Clamps.
www.patriotdocks.com