Paton StandardMIG -200, Техническое описание и руководство по эксплуатации

Страница: 21 / 37

-21 -
PATON StandardMIG MMA/TIG/MIG/MAG
diameter of installed wire (Ф0.6...1.2m). This configuration may be not optimal,
but, under condition of correct work, even wire feeding (without jerks) and correct
connection, this ‘ feeding machine” combination shall be able to weld so
far. For better results, adjust the source voltage with buttons
1 and wire feeding
speed by pressing buttons 12 on the wire-feeding machine according to general
recommendations on semiautomatic welding. Remember that these parameters
are different for each specific application.
5.1 WELDING CYCLE – MIG/MAG-2T
See Clause 6.1 for sequence of changing the value of any function in the
current welding mode.
5.1.1 FUNCTION OF BUTTON ON A 2T TORCH
It is used in welding of short and medium length welds. The function is as follows:
when pressing the button on the torch, the control signal enters the control unit,
the function of pre-purging the welding zone with gas during the time [t.Pr] (the
gas valve is opened) is processed, then a signal is given to turn on the source and
t, s
t, s
t, s