Paton MINI, Руководство пользователя, Страница: 51 / 55

- 51 -
PATON ECO DC MMA
9. DELIVERY SET
1. Welding arc supply source with a mains cable – 1 pce.
2. Shoulder carrying strap – 1 pce.
3.
PATON brand corrugated/plastic* box – 1 pce.
4.
3 m welding cable with an electrode holder – 1 pce.
5. 3 m welding cable with earth terminal – 1 pce.
6.
Operating manual – 1 pce.
*For MINI-C, ECO-160-C, ECO-200-C, ECO-250-C only
10. TROUBLESHOOTING
Fault Cause Correction
No arc current
The mains switch is on,
but the status indicator
is not lit.
Mains cable break Check the mains cable.
Supply mains voltage is
lower than 155 V Disconnect the machine
and connect it to the mains
with proper supply voltage
Supply mains voltage
exceeds
the
permissible value of
260 V
Disconnect the machine
and connect it to the mains
with proper supply voltage
Internal source supply
unit has failed Contact the service facility
No arc current
The mains switch is on,
the
source status
indicator lights green
Welding cables are
disconnected Check plug connection
Earth is not connected or
connected poorly Establish reliable connection
of the earth cable with the
work piece
No arc current
The mains switch is on,
the
source status
indicator lights yellow
Temperature sensor has
been actuated Wait until the machine cools
down; then it will switch on again
automatically
Insufficient cooling air
supply Provide sufficient air inflow
Temperature sensor is
faulty Contact the service facility
Bad striking during
welding with a stick
electrode,
the source
status indicator flashes
green for short periods
Supply mains voltage at
the start of loading is
near
the minimum
permissible value of 165
V.
If it is impossible to increase
cross‐section of feeding mains
cables, try reducing the set
current value, until it will allow for
striking the arc. Then use an
electrode corresponding to the
current value.
Continuation of table on page 14.