Paton MINI, Руководство пользователя, Страница: 46 / 55

PATON ECO DC MMA
- 46 -
1 – Digital seven-segment display.
2 – Arc current controller, allows for smooth adjustment of arc current.
3 – Mains supply status indicator:
a) permanent green light – the machine is ready for operation;
b) no light – no power supply or low voltage in mains.
4 – Machine operation indicator:
a)
no light – normal status of the device;
b) permanent red light – the device is overheated.
5 – Mains switch (does not light up, the colour is adopted for design purposes).
А – Power current socket "+" of bayonet type:
B – Power current socket " ‐ " of bayonet type:
2. START ‐ UP
ATTENTION: Before start‐up, read the chapter "Safety rules", paragraph 11 .
2.1 INTENDED USE
The welding machine is designed solely for manual arc welding with a stick electrode,
as well as for argon welding.
Other use of the machine is considered undue. The manufacturer is not
responsible for damage cause by undue use of the machine.
Intended use of the machine implies adherence to instructions of this operating
manual.
2.2 INSTALLATION REQUIREMENTS
The welding machine is protected from ingress of foreign solid objects of more
than 5.5 mm in diameter.
The welding machine can be placed and operated outdoors. Internal electric parts of
the machine are protected against direct moisture impact.
ATTENTION: Do not switch the machine off immediately after completion of
welding works in hot weather or intense welding works in any weather
conditions! Electronic parts must be allowed to cool down for 5 minutes.
ATTENTION: When the machine is switched off and cools down after operation
in cold season, condensate forms inside of it, so do not switch the machine on
again in less than 3...4 hours!!!
Therefore, don't switch the machine off in cold season, if you are going to switch it
on within 4 hours.
ATTENTION: The machine may be life‐threatening after a hard fall. So place it on
stable solid surface.