17
you are having this problem:
s:
:
2 2
TROUB
GU
LE SHOOTING
IDE
If
If this condition exist
You will need to do the following
1 4
The pilot light won’t light
ylinder valve is closed
ir in gas lines
eg. not fully engaged into tank
s pressure with cylinder valve
pen
Igniter is not sparking
r
alve in counter-clockwise direction
at
wo
inutes until you smell gas.
tor
E1 adapter for leaks or
amage
el level. Replace or refill
ylinder
ss
Seek
s. Replace igniter if
C
A
R
Low ga
o
Open valve at cylinder. Turn cylinde
v
Purge air by holding control knob
“PILOT” position for at least t
m
Hand tighten firmly. Check regula
and ACM
d
Check fu
c
Use match to light pilot through acce
hole at base of heater head.
service or check igniter wire
connection
required.
The pilot after initial lighting
ill not stay lit
that
safety
ystem in the regulator.
irt build up around pilot orifice
uple is not operating
roperly
ind condition blowing out pilot
ame
heel is fully tightened
oing into tank.
lean pilot orifice
30
econds. Replace Thermocouple
of
or at temperatures
w
There may be a leak in the system
has been detected by the
s
D
Thermoco
p
High w
fl
1 5
Check connections at hose to feed line
and feed line to heater head. Be sure
regulator hand w
g
C
Depress Knob in Pilot position for full
s
Put heater in more protected location.
Do not use heater in winds in excess
10 MPH. Do not use heater in high
wind conditions, rain,
below 40 degrees F.
1 6
Main burner will not light
as Pressure is low
afety System has detected a leak
“ON” position
urn cylinder off and replace
ert
G
Blockage in main burner orifice
S
Control knob is not in
1 7
T
Clear Spider web or other blockage
Turn tank off. Wait 5 minutes. Check
both fuel line connections. Reins
regulator tighten firmly and retry
Turn knob to “ON” Position
Burner Flame Is Low or
Emitter grid does not glow
venly.
r grid normally does not
glow.
ontrol knob not set to “ON” Position
heit and tank is less
an 20% full.
eater is not on a level surface
d refill cylinder
urn knob to “ON”
use full cylinder better
et go inside!
n heater onto hard and level
e
Please note: Bottom 1” of
emitte
Gas Pressure is low
C
Outdoor temperature is below 40
degrees Fahren
th
H
Turn cylinder off an
T
Refill tank and
y
Repositio
surface.
Carbon build up on emitter
grid or thick black s
moke
oming from head
irt or film on reflector or emitter grid.
lockage in burner
ter
lear spider webs or debris
ge
and check burner ports for blockage
c
D
B
Gently clean reflector or emit
C
Remove burner and remove blocka