PAT DS 50, Руководство оператора

Страница: 20 / 21

Operator's Manual DS 50 / 0002 16
7 TROUBLESHOOTING
General
In case of a malfunction of the system, the display (1) will indicate a code that identifies the system
malfunction.
The error codes listed in the Malfunction Table will identify various faults that can occur with the LMI.
Following the Malfunction Table are pages that explain each fault and describe the action that shall be
taken to correct the fault.
Faults within the electronic microprocessor shall be repaired by factory trained service personnel. When
these faults occur, the competent service organization shall be contacted.
Malfunction Table
Error Code Error
E01 Fallen below the radius or above angle range
E02 Radius range exceeded or fallen below angle
range
E03 Boom position is out of the permissible working
area
E04 Operating mode not existing
E05 Prohibited length range
NOTE:
If there is any Error Code displayed on the console which is not listed in the Malfunctions Table
you shall call the Local Distributor.