PAT DS 150, Руководство пользователя, Страница: 23 / 31

User Manual IK 150 / 0031 e
© 1997 PAT GmbH · D-76275 Ettlingen · Hertzstr. 32 - 34 ·
)
++49 (0) 7243 709-0 · FAX ++49 (0) 7243 709-222 · Email: pat.ettlingen@pat-gmbh.de
23
50 / 150 / 19_0031E.DOC / 19.03.1997 / Rev. C / rk.
Error Code Error Cause Elimination
E57 Error in serial crane
data EEPROM. •
Serial crane data EEPROM
does not contain valid data.
•
Memory module defective
•
Write data on the serial
crane data EEPROM (by
means of test program or
on-line function), then restart
the LMI
•
Replace memory module.
E58
Error in the serial
analog data
EEPROM. •
No valid data in the serial
analog data EEPROM.
•
LMI main board defective.
•
Write data on the serial
analog data EEPROM by
means of the test program,
then, restart the LMI
•
Replace LMI main board.
E69 Error in the load chart
EPROM
•
Memory module wrongly
bridged
•
Bridge memory module acc.
to memory type
The number of the
selected EPROM
base and the pro-
grammed value are
not identical
•
Load chart EPROM defec-
tive
•
Replace load chart EPROM
•
Base number not pro-
grammed
•
Program the correct base
number (1 for base 1, 2 for
base 2)
•
Load chart EPROM wrongly
programmed
•
Check base programming in
the load chart EPROM.
E71 Faulty acknowledg-
ment of relay K1 on
the connection board •
Relay K1 or connection
board defective.
•
Replace connection board.
Relay should be en-
ergized but the 2nd
contact is signaled to
be off or the 2nd
contact is signaled to
be on whereas the
relay should be de-
energized. •
LMI main board is defective
•
Replace LMI main board.
E72
...
E77 Faulty acknowledg-
ment of relays
K2...K7 on the con-
nection board.
•
refer to E71
•
refer to E71
E85
Error in the radius
determination •
The computed radius is too
small (negative deflection)
•
Check the programming in
the data EPROM.
E89 Operating mode
switchover with load. •
The operating mode on the
console has been switched
over with the boom loaded.
•
Select operating mode with-
out load on the boom
E91
No data transmission
form the console to
the central unit •
24 V supply of the console
is interrupted
•
Check 24 V at terminal X1 of
the console electronics