Troubleshooting
©PAT Rev. F 03/26/03
190136_f
13
9.1 LED’S
(Refer to Numbers below photo on previous page)
1.The LINK 1 LED Link1 (Green)
Indicates the status of the communication link
between the main hoist A2B transmitter and the
receiver. Failure of the communication link will
turn off the Green LED and turn off the output to
the lockout relay.
2. The A2B 1 LED A2B1(Red)
Indicates an impending two-block condition of the
main hoist. The Red LED will turn off when the
load-handling device has lifted the A2B weight.
This LED will light simultaneously with the
engaging of the lock-out solenoids (if installed).
3.The LOW BATTERY 1 LO BAT1 LED (Red)
When the light goes off, it indicates that the
battery of the main transmitter needs to be
replaced.
4. The LINK 2 LED Link2 (Green)
Indicates the status of the communication link
between the auxiliary hoist A2B transmitter and
the receiver. Failure of the communication link will
turn off the Green LED and turn off the output to
the lockout relay.
5. The A2B 2 LED A2B2(Red)
Indicates an impending two-block condition of the
auxiliary hoist. The LED will turn off when the
load-handling device has lifted the A2B weight.
This LED will light simultaneously with the
engaging of the lock-out solenoids (if installed).
6.The LOW BATTERY 2 LED LO BAT2 (Red)
When the light goes off, it indicates that the
battery of the main transmitter needs to be
replaced.
7. The ID 1 LED ID1(Orange)
Lights to show the successful setup of the main
transmitter. This LED will stay on once the
transmitter is set up.
8. The ID 2 LED ID2(Orange)
Lights to show the successful setup of the AUX.
Transmitter. This LED will stay on once the
transmitter is set up.
