Setup/Calibration
©PAT Rev. F 03/26/03
190136_f
7
5 SETUP/CALIBRATION
5.1.1 Setup
Overview
The PAT RATB is easily configured to communicate with up to 2 transmitters. Simply by pressing and
holding the yellow “ID” button for 7 seconds, the receiver can sense the transmitters being used and
configure the receiver to listen to only those transmitters. There are no numbers, ID’s or codes to
remember or write down.
5.1.2 Clear Existing Setup Switches
Press and hold the yellow “ID” button for 15 seconds, the ID LED will begin to blink and then go off
when cleared.
Note: It is only necessary to complete this operation when changing from a duel
switch setup to a single switch
. When setup is complete, the new transmitter switch will over write
the old ID code with a new one.
5.1.3 First ID Setup
To configure the system, install batteries into the transmitter to be used. Turn on the crane power.
Open the receiver enclosure and slide out the receiver board. Press and hold the yellow ID button on
the OEM module for 7 seconds until the ID 1 LED blinks. Release the yellow ID button. The receiver
will search for a transmitter for the next 30 seconds. Pull on the cable of the transmitter and then
release it. The yellow ID 1 LED should now be on solid. The transmitter and receiver are now set up
and will work only with each other.
ID SET
BUTTON