Pass XP-15, Руководство пользователя

Страница: 6 / 17

6
XP-15 Owner’s Manual
The single chassis XP-15 comes with two sets of input connections,
two sets of output connections, and a single 5-way binding post for
turntable grounding. These are located on the rear panel of the pre-
amplifier.
On the rear panel you will see two sets of 8 pole DIP switches for
each channel, these switches allow you select cartridge type (moving
magnet or moving coil), select gain, and adjust cartridge loading.
Next to the IEC inlet you will see graphic representation of how the
two pairs of switches interact. From the factory the XP-15 ships
with a default setting of moving coil at 100 ohms with a gain of 76
dB.
In order to set the XP-15 for your particular cartridge you will need
to have some salient information on the cartridge. If you do not
have that cartridge information please contact your dealer or the Pass
Laboratories factory. We will attempt to help you with that data, but
by no means do we have factory data on every cartridge ever built.
Please be aware that the XP-15 is a dual mono design, whatever
setting you select for one channel the other channel will need to be
set identically.
You will first need to select Moving Magnet (MM) or Moving Coil
(MC) as appropriate for your specific cartridge. In all instances the
switch-tab for any selection will need to up for “on” and down for
“off ”. If you have a moving iron cartridge, you will most likely
need to select Moving Magnet if the output is greater that 2mV. A
moving iron cartridge with an output of less than 1mV will typically
Adjustment