Pass XA25, Руководство пользователя, Страница: 5 / 8

OUTPUT CONNECTIONS AND LOUDSPEAKERS
The rear of the XA25 is equipped with a pair of Furutech binding posts for each channel,
four total. The binding posts are marked red and black.
The Red output connector connects to the Red (+) of your speakers and the Black connec -
tor will connect to the Black (-).
The Black output connector is at circuit ground. You can use it to connect to powered
sub-woofers if you like.
The amplifier is stable into any load which does not dip below 0.5 ohms, but it will protect
itself by shutting off any channel which outputs more than 10 amps (200 watts peak into 2
ohms). The protection circuit is reset by turning the amp off for a few moments and then
turning it back on. We recommend that you check your output wiring and/or the loudspeak-
er if this happens, and contact your dealer or the factory if you have problems.
The Furutech binding posts deserve special note - in keeping with the requirements of Class
2 circuits in North America they are fully insulated. Speaker cables connected as intended
will have no exposed conductive metal. The Furutech posts accept banana, spade, bare wire
or pins with a diameter of 4.5mm or less. Bare wire, pins and spades socket into the binding
post only from the bottom. The nuts on the binding posts should only be finger tight. Nev -
er tighten with wrench or pliers.
NOTE - The Audio outputs of power amplifiers are considered class 2 (CL2) circuits in
North America. This means that the wire connected between the amplifier and the speak -
er(s) shall be rated at minimum Class 2 (CL2) and shall be installed according the the U.S,
National Electrical Code (NEC) Article 725 or Canadian Electrical Code (CEC) section 16.
OPERATION
Once the speakers have been connected in observation of the proper regulations and with
the observation of polarity and phase you may attach the input cables and power cord. It is
always advised that the power cord is the last connection made and the first to be removed.
You are now ready to play music. Turn the level at the source or preamp to a low level.
Press the power switch on the front panel of the XA25, the blue LED above the power
switch will light. Turn the volume up to your preferred listening level. Sit back and enjoy!
The XA25 takes approximately an hour to fully warm up and sounds better as it does. Push-
ing the power button on the front panel of the XA25 a second time turns it off and extin-
guishes the blue LED.