6
Successive (Bounce) Driving - (Orange Trigger)
■
Grasp the handle firmly.
■
Squeeze the trigger and move the tool along the work-
piece with a bouncing motion, depressing the work con-
tacting element at the points where you want to insert a
fastener.
■
Keep the trigger depressed and continue to bounce the
work contacing element against the workpiece, positioning
the tool above as carefully as possible.
■
When the desired number of fasteners have been driven,
release the tool trigger to avoid unintentional fastener dis-
charge.
Sequential Operation - (Gray Trigger)
The sequential operating kit prevents successive or
“bounce” driving.
■
Depress the work contacting element and hold it against
the work surface before pulling the trigger.
■
After each fastener is driven, completely release the trig-
ger and lift the tool from the work surface.
TOOL OPERATION -
continued
Use only fasteners that meet Paslode specifications.
Use of fasteners that do not meet Paslode specifica-
tions can result in damage to the tool or injury to the
operator or bystanders.
WARNING
Note:
Follow the siding manufacturerʼs instructions
when installing the nails.
Always use the nail
size specified by the siding manufacturer and/
or the local building codes.
®
®
Precision Placement Driving - (Orange Trigger)
■
Grasp the tool handle firmly and hold the bottom of the
work contacting element firmly against the workpiece until
it is completely depressed.
■
Squeeze the trigger to drive the fastener.
■
Lift the tool from the workpiece.
■
Repeat the procedure for the next fastener.
Driving of Nails
■
A
B
C
CHANGING THE TRIGGER
1. Disconnect the tool from air source.
2. Remove trigger step pin rubber retaining rings (
A
).
3. Remove trigger step pins (
B
).
4. Remove sequential trigger assembly
C
(Gray) and spring.
5. Install Trip trigger
D
(Orange)
with spring and align hole and
reinsert trigger step pins.
6. Reinstall rubber retaining rings and
check for correct operation.
D
DUAL MODE
TRIGGER ACTUATION SYSTEM
FOR CONTACT ACTUATION
USE ORANGE TRIGGER.
IN THIS MODE THE TOOL WILL
CYCLE BY DEPRESSING THE
SAFETY YOKE AND THE TRIGGER.
NO SEQUENCE IS NECESSARY.
FOR SINGLE SEQUENTIAL
ACTUATION USE GREY TRIGGER.
IN THIS MODE THE TOOL WILL ONLY CYCLE
WHEN THE SAFETY YOKE IS DEPRESSED
FOLLOWED BY TRIGGER ACTUATION.
THE TOOL WILL CONTINUE TO CYCLE BY REPEATED
TRIGGER ACTUATION PROVIDED THE SAFETY YOKE
REMAINS DEPRESSED.
USE ONLY AFTER RECEIVING INSTRUCTIONS ON SAFE OPERATION.
